How to maintain CNC lathe equipment?

How to maintain CNC lathe equipment?

CNC lathe is the demand for oil maintenance, which most people are more questionable.Then please allow me to answer!Fully automatic CNC lathe as well as your car, buy back, later to pay attention to the health of the stage, in order to avoid dust and scrap iron in orbit, the high precision CNC lathe manufacturer into the damage will be occurring after precision is not good, feel is heavier, turbulence are heavy, hard work, so, "fully automatic CNC lathe" like your car, be careful to buy back, later to pay attention to the health of the stage, in order to avoid dust and scrap iron in orbit, the early stage of the new fully automatic CNC lathe oil should be replaced once a month, a year of change in the next three months time, three times in the first three months of replacement.Full active CNC lathe oil can be replaced, also can reduce the CNC lathe track impurities, it will flow along the new oil into the oil tank, can not stay in the track, will not hurt the track.Wenzhou precision CNC lathe manufacturers oblique bed body CNC lathe manufacturers about the daily protection of CNC lathe as follows:

Investigate the height of the lubricating oil level to ensure the lubrication of the machine.

Investigate whether the coolant in the tank is sufficient and cannot be increased immediately.

Check the oil level of the air triplet product, about 2/3 of the tubing height.Drain the water from the 3 - pin filter tank through the drain switch every day.

Investigate the air pressure, loosen the adjusting knob, and adjust the pressure according to the principle of right-rotation pressure and left-rotation decompression, generally set as 7KG/CM2.The pressure switch is generally set as 5KG/CM2, which is lower than the alarm when 5KG/CM2 is used. "LOWAIRPRESSURE" alarm appears in the system. After the pressure rises, the alarm information disappears.

To investigate whether the air blowing in the spindle cone hole of CNC lathe is normal or not, zhejiang precision CNC lathe manufacturers wipe the cone hole in the spindle with clean cotton cloth and spray it with light oil.